Setting The Channel Switch; Connecting Power; Using Ac Power - RCA 40 Owner's Manual

SETTING THE CHANNEL
SWITCH
, on the back of the VCP,
CHANNEL
determines on which channel a standard TV
receives the VCP's signal. Set
for channel 3, or
4
VIDEO
OUT
AUDIO
OUT
Notes:
• If possible, set
on which you do not receive regular
television broadcasts.
• The
CHANNEL
the audio and video outputs, nor does it
affect a standard TV's operation when
the VCP is not playing a tape.

CONNECTING POWER

Using the supplied adapters, you can power
your VCP from either a standard AC outlet
or your vehicle's cigarette-lighter socket.
Cautions:
• If you use the VCP in areas of high
humidity or move it from a cold area to
a warm one, allow it to warm up for
about 2 hours before you plug it in and
operate it, so any moisture inside can
completely evaporate.
10
CHANNEL
for channel 4.
CHANNEL
ANT.IN
3
4
CHANNEL
RF.OUT
DC IN 12V
to a channel
CHANNEL
setting has no effect on
• If moisture has formed inside the VCP,
it might not operate after you connect
power (see "Dew Protection System" on
Page 12).
to

Using AC Power

3
The supplied AC adapter lets you power the
VCP from a standard AC outlet.
Cautions:
!
Its center tip must be set to positive and
its plug must fit the VCP's
jack. The supplied adapter meets these
specifications. Using an adapter that
does not meet these specifications could
damage the VCP or the adapter.
• When you unplug the AC adapter,
grasp the adapter's plug, not its cord.
• Always plug the AC adapter into the
VCP before you plug it into the AC
outlet. Always unplug the AC adapter
from the outlet before you unplug it
from the VCP.
You must use a Class 2 power
source that supplies 14V DC
and delivers at least 850 mA.
DC IN 12V