Table of Contents
Advertisement
3
Installation
3.1
Contents of Delivery
1
1
Fig. 8
Contents of delivery
i
Notice!
Please keep the original packaging in case the applicator must be returned.
!
Attention!
The device and printing materials will be damaged by moisture and wetness.
Set up label printer with applicator only in dry locations protected from splash water.
3.2
Mounting the Applicator to the Printer
!
Attention!
Disconnect the printer from the power supply before mounting the applicator !
Ensure a stable standing of the printer !
Connect the compressed air only after mounting the applicator to the printer !
1
Fig. 9
Mounting the applicator
1. Insert the pins (15 / fig. 3) on the back of the applicator (2) into the holes (3) of the printer.
2. Press the applicator against the printer. That way the plug of the applicator will be connected to the peripheral port
(4) of the printer.
3. Fix the applicator (2) with the screw (1).
2
3
2
3
2
3
4
1 Applicator
2 Pad (as ordered)
3 Cylinder screw
(part of the pad)
4 Piercing pin
(at universal tamp pads only)
- Documentation
4
4
9
Advertisement
Table of Contents
