Configuration; Method For Changing The Printer Setup; Quick Mode For Setting The Delay Times - CAB A1000 Operator's Manual

Configuration

4
The tamp applicator can be operated in different ways. While the original process stays the same, the operation
mode can be chosen within the printer setup.
The most important setting is the selection between the operation modes "Stamp on", "Blow on" and "Roll on".
Additionally the applicator has different application modes concerning the order of printing and applying within one
labelling cycle.
Print/Apply
Apply/Print
Waiting position up
Apply/Print
Waiting position down
Table 2 Operation and application modes
Additionally all operating modes can be adjusted by setting different time delays.
i
Notice!
For more information about the printer configuration and the function of the keys in the navigator pad
 Configuration manual of the printer (A+ series) or  Operator's manual of the printer (A series).
Die following description apply to the printers of the A+ series. For printers of the A series there are
marginal differences in the key functions.
4.1

Method for Changing the Printer Setup

1. Press menu key.
2. Select Setup > Machine param. > Applicator.
3. Select and adjust the needed parameters.
4. Return to the "Ready" mode.
4.2

Quick Mode for Setting the Delay Times

Beside the standard method for the printer configuration there is a quick mode to adjust the delay times available.
i
Notice !
The quick mode settings can be made during operation . The changes affect directly the current print job.
1. Press the menu key for at least 2 seconds.
The first delay time appears on the display.
2. Adjust the delay time by pressing the ~ key and € key.
3. To switch between the different delay times press the } key.
4. To leave the quick setup mode press the | key.
The selected delay times are stored in the printer.
Stamp on Roll on
x
x
-
Blow on
x x
x x
- x
13