Table of Contents
Advertisement
5
Adjustments
16
5.1.2
Adjusting the Parallelism between Pad and Dispense Edge
Fig. 16
Adjustment of parallelism
5.1.3
Opening the Holes on the Blow Tube
Fig. 17
Opening the holes on the blow tube
5.1.4
Aligning the Blow Tube
Fig. 18
Alignment of the blow tube
The blow tube (2) for the supporting air can be rotated around its axis. That way the direction of the supporting air can
be optimized.
1. Loosen screw (1).
2. Turn the blow tube (2) in that direction, that the air current supports the sucking of the label by the pad.
•
For small labels direct the air current to the dispense edge (3) of the printer (setting 3 or 4 at the scale).
•
For larger labels direct the air current away from the dispense edge (3) (setting 1).
3. Tighten screw (1).
1
2
3
1
2
3
1
2
1. Loosen screw (1).
2. Adjust the parallelism between the rear edge of the pad (2) and the
dispense edge (3) by turning the pad.
3. Tighten screw (1).
The blow tube (1) has holes for the supporting air in regular distances of
15 mm.
When the applicator is delivered only the two inner holes are open. The
other holes are closed by plastic rings (3).
To adjust the supporting air to the label width, the plastic rings (2) can be
removed from the holes.
Open all holes, which affect certainly the area of the label.
3
2
4
16
Advertisement
Table of Contents
