Table of Contents
Advertisement
5
Adjustments
5.1.5
Adjusting the Stopper
2
3
Fig. 19
Adjusting the stopper
i
Notice!
For operation mode "Blow on" only !
!
Attention!
Switch off the printer and close the shutoff valve for the compressed air at the service unit !
1. Place a product sample (7) at the labelling point.
2. Pull the tubes out of the push-in-fittings (1,5).
3. Loosen the screw (3) in the stopper (2).
4. Move the pad manually in the required labelling position. The distance between the blow pad (6) in the labelling
position and the product surface (7) must not exceed 10 mm.
5. Move the stopper (2) against the guide block (4) and tighten the screw (3).
6. Insert the tubes into the appropriate push-in-fittings (1,5).
7. Open the shutoff valve and switch on the printer.
1
4
5
6
7
17
Advertisement
Table of Contents
