Connections - CAB A1000 Operator's Manual

3 Installation
12
3.7

Connections

Attention!
!
The pad will immediately be moved in the starting position !
Danger of crushing to hand and fingers by the moving pad !
 Do not reach into the zone of the moving pad and keep long hair, loose clothes, and jewelry distant.
Danger of striking by the moving rods !
1
Fig. 14 Compressed air connection
1. Prepare the printer connections to the power supply and to the computer  Operator's manual of the printer.
2. Connect the PLC interface using the 15-pin or 25-pin connector  "PLC Interface".
3. Close the shutoff valve (3 / lever at the valve is turned across the air flow direction).
4. Connect the applicator to the compressed air supply.
The connector (2) for the compressed air supply is located at the service unit. The connector is suitable for a 1/4"
coupling plug (1).
5. The air pressure for operating the applicator is pre-adjusted to 0.5 MPa (5 bar).
Check the pressure at the manometer of the service unit. Correct the adjustment if necessary :
- Pull knurled knob (4) up.
- Turn knob to tune required operating pressure of 5 bar.
- Push knob down.
6. Open the shutoff valve. (3 / lever is turned in the air flow direction)
7. Switch on the power supply of the printer.
i
Notice!
In case the pad is outside the start position in the moment of switching on it will interupted the procedure
and give notice an error message on the display of the printer.
If you push the button PAUSE on the printer is receipt the error and the applicator will move into the start
position.
The Applicator is ready for work.
2 3 4 5
12