Table of Contents
Advertisement
3
Installation
10
3.3
Piercing the Universal Tamp Pad
On the bottom of the pads there are holes for sucking and holding the labels by vacuum. When an universal tamp
pad is delivered these holes are covered by the sliding foil and must be opened according to the label size. For that
purpose a piercing pin is included in the contents of delivery.
1
2
Fig. 10
Piercing the universal tamp pad
1. Place a label (1) to be operated on the bottom side of the pad (2). Note the position of the slanted edge (3).
2. Align the label to the side edge in such a way that it reaches over the rear edge of the pad by 2 mm.
3. Open all the holes, which are certainly covered by the label. Open the holes completely by turning the piercing pin
(4) inside the holes.
!
Attention!
Do not open holes, which are located less than 1 mm from a label edge.
3.4
Preparing the Applicator for Using a Tamp Pad Type 1312
The cylinder unit (6) can be mounted on the bracket (1) in two different positions.
When the applicator is delivered, the cylinder unit is mounted on the bracket using the upper threaded hole (4). That
position is suitable for the most pads.
1
2
3
Fig. 11
Changing the attachment of the cylinder unit
For using an universal tamp pad type A1312 the fitting of the cylinder unit must be changed :
1. Loosen the screw (3) with washer (2) and remove the cylinder unit from the bracket (1).
2. Fix the cylinder unit with screw (3) and washer (2) by using the lower threaded hole (5).
4
3
4
5
6
10
Advertisement
Table of Contents
