Adjustments; Mechanical Adjustments; Aligning The Pad - CAB A1000 Operator's Manual

5

Adjustments

5.1

Mechanical Adjustments

Perform the mechanical adjustments in two steps :
 Roughly align the pad in all directions to avoid collisions of the pad with other parts when switching on the
compressed air.
 Perform the fine adjustment with compressed air switched on to optimize the labelling process.
5.1.1

Aligning the Pad

Fig. 15 Aligning the pad
Adjustment in print direction
1. Loosen screw (3).
2. Shift the cylinder unit including the pad (4) inside the elongated hole in such a way, that the distance between the
pad and the dispense edge is about 2 mm.
3. Tighten screw (3).
Height adjustment
1. Loosen screw (1).
2. Shift the cylinder unit including the pad (4) inside the elongated hole in such a way, that the lower rear edge of the
pad is located about 1 mm below the dispense edge of the printer.
3. Tighten screw (1).
Side adjustment
1. Loosen screw (2).
2. Shift the cylinder unit including the pad (4) inside the elongated hole in such a way, that the dispensed label is
aligned centrally to the pad respectively to the open holes in an universal pad.
3. Tighten screw (2).
i
Notice !
 Check the adjustments with compressed air switched on.
1
2
3
4
4
5
2
15