Pin Assignment And Signal Description - CAB A1000 Operator's Manual

7 PLC Interface
24
7.1

Pin Assignment and Signal Description

i
Notice!
The numbers in the brackets apply to the 15 pin connector !
Pin Pin
25 pin 15 pin
1 1 E0.1 (+)
2 2 E0.2 (+)
3 3 E0.3 (+)
4 4
5 5
6 6
7 7
8 8
9
10
11
Signal Signal Description
A1000 Hermes Appl.
XSTART Start signal for the cyclic labelling process.
XSTOP Stop signal (external error)
The following functions are released :
•
•
•
•
•
Print first label
XDREE
for application mode "Apply/Print" only :
releases the print of the first label and its
picking-up by the pad
A0.1 XDNB Printer not ready
Error message of the printer.
The error type is shown on the display.
After error correction, the print of the last label
will be repeated.
A0.2 XEDG No existing print job.
State message.
There is no print job currently available.
A0.3 XSAA General error message
General error message of both, printer and
applicator. This message is shown when one of
the two errors either XDNB or XETF occurs.
Important in case that only one error signal
of the applicator can be analyzed from the
system control.
A0.4 XSOE Pad in starting position
The pad is in the starting position where it
picks up the label from the printer.
GND GND Ground (0V)
Attention !
 Do not connect Pin 8 with the ground of the
A0.5 Special signal x command (bit 0)
is controlled by the X command in the direct
programming
for detailed description of the X command
 Programming manual
not connected
E0.5 (-) External reset (reverse line)
the print of a label and its picking-up by the
pad will be finished
the labelling process is interrupted
the pad returns into the starting position
all following start signals are ignored
if activated during the labelling phase, the
display will show the message 'Host stop/
error'. (no message during print process)
PLC. Otherwise the galvanic separation
would be lost.
Activation / Active state
Switch on +24V between
Pin 1 and Pin 14 (9)
Switch on +24V between
Pin 2 and Pin 15 (10)
Switch on +24V between
Pin 3 and Pin 16 (11)
Contact between Pin 4 and
Pin 19 (14) is open
Contact between Pin 5 and
Pin 19 (14) is open
Contact between Pin 6 and
Pin 19 (14) is open
Contact between Pin 7 and
Pin 19 (14) is open
if Bit 0 is set :
Contact between Pin 9 and
Pin 19 is closed
24