Appendix C: Installing The Lap-Teq Inclinometer; Appendix D: Safety Pin Mechanism On Shackles - L-Acoustics SB18 Rigging Manual

APPENDIX C C C C : : : : INSTALLING THE LAP-TEQ INCLINOMETER APPENDIX
APPENDIX APPENDIX
A laser support plate has been integrated to the M-BUMP and the KARA-MINIBU for the optional installation of the
®
TEQSAS LAP-TEQ inclinometer. The LAP-TEQ is a remote control device which is part of the L-ACOUSTICS
TECH TOOLCASE.
LAP-TEQ inclinometer installed on the M-BUMP (left) or the KARA-MINIBU (right)
Required material
Electric screwdriver with torque selector, T20 Torx
Put the M-BUMP or KARA-MINIBU with identification plate right-side up.
®
Undo the four Torx bolts on the laser support plate (T20 bit, 7 mm hex key).
Place the LAP-TEQ on the laser support plate with laser lens towards the front laser slit, verifying nothing obstructs
the slit opening.
®
Drive the four Torx bolts into the holes of the inclinometer and the plate (T20 bit, 7 mm hex key, 3 N.m/27 in.lb
Calibrating the LAP-TEQ
Refer to the manufacturer instructions in the L-ACOUSTICS
handheld inclinometer available in the TOOLCASE, an XLR3 cable is needed.
APPENDIX D: APPENDIX D: APPENDIX D:

APPENDIX D: SAFETY PIN MECHANISM ON SHACKLES

Securing the shackle
ALWAYS put the safety pin in locked position to secure an assembly
SB18_RM_EN_1-0
®
bit, 7 mm hex key
Unlock
Lock
w w w . l - a c o u s t i c s . c o m
®
TECH TOOLCASE. In addition to the
®
).
f
17 17 17 17