Preparing The Kara-Minibu Flying Structure - L-Acoustics SB18 Rigging Manual

D.

Preparing the KARA-MINIBU flying structure

Required material
Electric screwdriver with torque selector, 6 mm hex bit, 13 mm hex key
Attach two KARA-MINIBUEX to the KARA-MINIBU.
a. Place a KARA-MINIBU at the rigging location with the identification plate right-side up;
b. On each side, install one KARA-MINIBUEX, with feet up, by inserting one of its stud into a KARA-MINIBU slit;
c. Secure the assembly by driving 3 bolts on each side (6 mm hex bit, 13 mm hex key, 7 N.m/63 in.lb
Orientation of the KARA-MINIBU frame
The KARA-MINIBU frame is symmetrical so that the installation as a front or rear extension can be
achieved wherever the KARA-MINIBUEX are installed. However, it is recommended at this step to
anticipate the front or rear extension so as to keep the laser plate at the front of the array.
Attach the shackle(s) to the KARA-MINIBU, in the hole(s) corresponding to the chosen flying option and providing
the desired site angle (see modeling in SOUNDVISION and APPENDIX B).
If needed, install a laser device on the laser plate (see APPENDIX C).
A MINIBUEX stud being inserted
b
into a KARA-MINIBU stud
A Ø12mm bow shackle
being attached
SB18_RM_EN_1-0
PROCEDURE D : Preparing the KARA-MINIBU flying structure
c
A CLAMP250
being attached
w w w . l - a c o u s t i c s . c o m
The MINIBUEX/KARA-MINIBU assembly being secured
on one side with 3 hex screws (M8 x 25 mm) and 3 nuts
The KARA-MINIBU flying structure ready
END
(Option 4, see APPENDIX B)
).
f
13 13 13 13