Preparing The M-Bump Flying Structure - L-Acoustics SB18 Rigging Manual

SB18 SUBWOOFER SB18 SB18 SB18
rigging manual rigging manual
rigging manual rigging manual
VERSION 1.0
C.

Preparing the M-BUMP flying structure

Refer to the modeling in SOUNDVISION and to APPENDIX A to choose the flying option for the M-BUMP
structure, determining the number of M-BAR (0, 1 or 2) and their rigging position (rear or front extension, A or B).
Depending on the chosen flying option, attach one or two shackles to the M-BUMP or M-BAR(s), in the hole(s)
providing the desired site angle.
If needed for the chosen flying option, attach one or two M-BAR to the M-BUMP.
a. Remove both pins from the M-BAR(s);
b. Place the M-BAR(s) on the M-BUMP by inserting the M-BAR studs into the M-BUMP slits;
c. Secure the assembly by re-inserting the pins previously removed from the M-BAR (s).
If needed, install a laser device on the laser plate (see APPENDIX D).
A Ø19mm bow shackle
being attached to the M-BAR
END
SB18_RM_EN_1-0
PROCEDURE C : Assembling the M-BUMP flying structure
The M-BUMP flying structure ready (Option 4, rear extension, position B)
w w w . l - a c o u s t i c s . c o m
b.
c.
An M-BAR being attached to the M-BUMP
(Option 4, rear extension, position A)
b
.
c.
12 12 12 12