Replaying Continuously; Turning Off The Replay Function; Capturing 100 Intermittents Automatically - Fluke 190-102 User Manual

Replaying Continuously

You can also replay the stored screens continuously, like
playing a video tape.
To replay continuously, do the following:
1 From Scope mode, open the
REPLAY
REPLAY
Observe that the waveform is
frozen and
top of the screen.
2 Continuously replay the stored
F3
screens in ascending order.
Wait until the screen with the signal event of interest
appears.
Stop the continuous replay.
3
F3
menu.
appears at the
REPLAY
Using Replay, Zoom and Cursors
Replaying the 100 Most Recent Scope Screens

Turning Off the Replay Function

4
F4

Capturing 100 Intermittents Automatically

When you use the test tool in triggered mode, 100
triggered screens are captured.
By combining the trigger possibilities with the capability of
capturing 100 screens for later replay, you can leave the
test tool unattended to capture intermittent signal
anomalies. This way you could use Pulse Triggering to
trigger and capture 100 intermittent glitches or you could
capture 100 UPS startups.
For triggering, see Chapter 4: "Triggering on Waveforms".
Turn off .
REPLAY
3
51