Replacing The Battery Pack - Fluke 190-102 User Manual

Replacing the Battery Pack

Warning
Use only the Fluke BP290 (not recommended
for 190-xx4) or BP291 for replacement!
When no adapter power is supplied, data not yet saved in
the test tool memory is maintained if the battery is
replaced within 30 seconds. To avoid loss of data, do one
of the following actions before removing the battery:
− Store the data in the test tool's non volatile flash
memory, on a computer or a USB stick.
− Connect the power adapter.
To replace the battery pack, proceed as follows:
1. Remove all probes and/or test leads
2. Remove the standup or fold it to the test tool
3. Unlock the battery cover (Figure 47)
4. Lift the battery cover and remove it, (Figure 48)
5. Lift one side of the battery and remove it (Figure 49)
6. Install a battery and close the battery cover.
Maintaining the Test Tool
Replacing the Battery Pack
Figure 47. Unlocking the Battery Cover
7
97