P2-3 Check The Free-Wheel Configuration - Gs-84 And Gs-90 - Genie GS-1530 Maintenance Manual

September 2016
GS-69, GS-84, GS-90
Replace the Medium and High Pressure
Hydraulic Filter(s)
1 Locate the medium and high pressure filter(s).
2 Remove the filter housing using a wrench on
the nut provided on the bottom of the housing.
3 Remove the filter element from the housing.
4 Inspect the housing seal and replace it if
necessary.
5 Install the new filter and hand tighten the
housing onto the filter head.
6 Use a permanent ink marker to write the date
and number of hours from the hour meter on
the oil filter.
7 Inspect the filter assembly to be sure that
there are no leaks.
8 Clean up and properly dispose of any oil that
may have spilled during the installation
procedure.
Part No. 1272215
Programmed Maintenance Procedures
P2- 3 C hec k the Free-wheel Confi gur ati on - GS-84 and GS- 90
P2-3
Check the Free-wheel
Configuration - GS-84 and GS-90
Genie requires that this procedure be performed
every 2000 hours.
Proper use of the free-wheel configuration is
essential to safe machine operation. The
free-wheel configuration is used primarily for
towing. A machine configured to free-wheel without
operator knowledge may cause death or serious
injury and property damage.
Non-Steer wheels:
1
2
3
Scissor Lifts
Collision hazard. Select a work
site that is firm and level.
Component damage hazard. If
the machine must be towed, do
not exceed 2 mph / 3.2 km/h.
Chock the steer wheels to prevent the
machine from rolling.
Center a lifting jack of ample capacity
(20,000 lbs / 10,000 kg) under the drive
chassis between the non-steer tires.
Lift the wheels off the ground and then place
jack stands under the drive chassis for
support.
Maintenance Manual
77