Genie GS-1530 Maintenance Manual page 67

Maintenance Manual
Annual Maintenance Procedures
Check the Descent Delay
Function
1 GS-69: Raise the platform approximately 10 ft
/ 3 m.
GS-84 and GS-90: Raise the platform
approximately 15 ft / 4.6 m.
2 Lower the platform until the down limit switch
activates and the platform stops lowering.
Quickly release the controls and then
immediately attempt to lower the platform to
the stowed position.
Result: The platform will not lower for 4 to
6 seconds. Release the joystick and proceed
to step 3
Result: The platform continues to lower.
Confirm that the descent delay option has
been selected to on. Refer to Repair
Procedure in the appropriate Service and
Repair Manual for your machine,
Setup the Machine or Software Configuration
Repeat this procedure.
3 Lower the platform to the stowed position.
56
Check the Down Limit Switch
Height
1 GS-69: Raise the platform approximately 10 ft
/ 3 m.
GS-84 and GS-90: Raise the platform
approximately 15 ft / 4.6 m.
2 Lower the platform until the down limit switch
activates and the platform stops lowering.
3 Push in the red Emergency Stop button to the
off position.
4 Measure the distance between the working
surface and the platform deck.
GS-2669
GS-3369
GS-4069
How to
.
GS-3384
GS-3390
GS-4390
GS-5390
Scissor Lifts
September 2016
63 to 69 inches
1.6 to 1.75 m
66 to 72 inches
1.7 to 1.83 m
76 to 82 inches
1.9 to 2.1 m
95 to 107 in
2.4 to 2.7 m
106 to 118 in
2.7 to 3.0 m
118 to 130 in
3.0 to 3.3 m
Part No. 1272215