Configuring The Secure Pumppay Software; Using The Keypad - VeriFone MX 760 Configuration Manual

1

Configuring the Secure PumpPAY Software

This chapter describes how to configure Secure PumpPAY MX 760 terminal after the Retrofit Kit has
been installed.
Important:Before you begin, be sure the switch on the RS232/RS485 Converter (P/N 13976-01) is
set to 2W (2-wire). If the switch is not set correctly, DCR communications between
Secure PumpPAY and the Ruby will fail. Also, make sure the converter is connected to
the power port of the Ruby.

Using the Keypad

The keys you use to configure the MX 760 terminal are described in the following illustration.
Scroll back
through
options.
Enter
numeric
data.
Note: Press [
*
cursor to the right.
November 10, 2011
ENTER. Select options
and accept numeric entries.
]
on the keypad to move the cursor to the left. Press [#] on the keypad to move the
Scroll ahead
through
options.
CANCEL.
Reject or delete
entries.
CLEAR.
Go back to
previous
menu.
1