Running Gemstall For Shell Sites - VeriFone MX 760 Configuration Manual

Secure PumpPAY Retrofit Kit Configuration Guide

Running Gemstall for Shell Sites

For Ruby only sites, use rel.vfg; for Sapphire sites, use relsapp.vfg. When you run Gemstall, select the
following options for Secure PumpPAY:
1. Under Select Dcr System, select the new "D_Secure_Pump_Pay" option. If you are changing
configuration bits in the next menu, make sure you keep the fifth bit as a "1" because this will
be looked at by the software (original bits: 1000-1000 and you can change them to 1000-1111).
2. Under Select Dcr Keypad, select the new "v2001" keypad.
3. Under the new Select SPP Prompt menu, select one of the available prompts.
4. Under the Station_DcrGraphic menu, do one of the following:
– For SHOPAK versions 4.04.06 or prior, select one of the following:
Shell_NoGraphicDcr
Texaco_NoGraphicDcr
NoBrand_NoGraphicDcr
– For SHOPAK versions 5.00.00 and later, select one of the following:
Shell_GrfxSPP
Texaco_GrfxSPP
NoBrand_GrfxSP
Note: If the Gemstall version that contains the Secure PumpPAY configuration options is not
available, select the following options:
– Wayne DCR
– Wayne keypad 2001
– Wayne Prompt (any one, W1_01 will work)
– Wayne Graphics
– Fuel will be whatever it was previously at the site because the MX 760 only changes out
the DCR.
After you have run Gemstall, do the following for all SHOPAK versions:
1. Enter Fuel Manager and make the following settings for each DCR:
Fuel Manager ->
8. DCR Configuration -> DCR Attributes -> DCR #01
13. Enable graphic support - Y
15. Graphic keypad -> Y
16. Graphic display ->Mono+ROM
17. Graphic screen size: 5 inch
18. Text Lines: Full Scr
2. Enter Network Manager using the backdoor password and set the following:
Network Manager ->
17. Configuration ->
6. Debit Configuration -> Debit Encryption Method: 1 = DUKPT
64 November 10, 2011