Martin JEM ZR25 User Manual page 7


Block access below the work area and work from a stable platform
whenever installing, servicing or moving the machine.

Do not operate the machine with missing or damaged covers or shields.

In the event of an operating problem, stop using the machine
immediately and disconnect it from power. Do not attempt to use a
machine that is obviously damaged.

Do not modify the machine in any way not described in this manual or
install other than genuine Martin parts.

Refer any service operation not described in this manual to a qualified
technician.

Fog output can cause condensation. Do not point the output at smooth
floors. Floors and surfaces may become slippery. Check these frequently
and wipe dry as necessary to avoid any danger of slipping.

Ensure at least 2 m (6.6 ft.) visibility in areas where fog is being
produced.

Fog fluid contains food-grade glycols in solution that may present health
risks.
IF SWALLOWED: Do not induce vomiting. Drink 1-2 glasses of water
and seek medical attention.
AVOID CONTACT WITH SKIN AND EYES: In case of accidental
contact: EYES: Hold eyes open and flush with water for ten minutes,
seek medical attention if irritation persists. SKIN: Remove contaminated
clothing and rinse skin for 20 minutes, seek medical attention if irritation
persists.
Consult the fluids' SDS for more detailed safety information at
http://www.martin.com/safety-documents

This machine is not intended for use by persons (including children) with
reduced physical sensory or mental capabilities, or lack of experience
and knowledge, unless they have been given supervision or instruction
concerning use of the machine by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the
machine.
P r e v e n t i n g b r e a t h i n g p r o b l e m s

A machine can operate safely only with the fog fluid it is designed for.
Use the machine only with fluids specified under "Approved Fog Fluid
types" on page 20 or you may cause the release of toxic gases,
presenting a severe health hazard. You will also probably damage the
machine.

Do not create dense fog in confined or poorly ventilated areas.

Do not expose people with health problems (including allergic and/or
respiratory conditions such as asthma) to fog output.

Do not point fog output directly at a person's face or at face height.
For the latest user documentation and other information for this and all Martin
products, please visit the Martin website at http://www.martin.com
If you have any questions about how to install, operate or service the fixture
safely, please contact your Martin distributor, dealer or contact Martin Service
and Support.
Safety information
7