Sharp MX-2640N Technical Manual page 56

IMAGE SEND COMMUNICATION ERROR
Report Code
Result Displayed
(Result)
0 - 31
Refer to "previous table".
33
34
35 NG35 XXXX
36 No record paper
37
Record paper jam
38 MEM. FULL
39 No. of paper unmatched
40 Relay not received
41 LENGTH OVER
42 LENGTH OVER
43
Communication (OK)
44 ORIGINAL ERROR
45 Picture quality error
46 NO RESPONSE
47
TX DECODE ERROR
48
OK REPLY RECEIVE
49
NO RX POLL
50 RX POLL FAIL
51 PASS # NG
No confidential function
52
in remote party
53 Confidential not received In confidential sending, DCN is received for NSS. <Send>
54 Confidential BOX NO NG
No relay function in
55
remote party
56 NO REL RX
57 Relay ID unmatched
56
Depends on the point of communication interruption. For 16 or later, V.34
mode communication.
BUSY The calling side cannot establish connection with the remote party.
A communication interruption command is made during sending/receiving.
CANCEL The interruption key is pressed for interruption of input.
<Send/Receive/Polling/Bulletin board>
Power is failed during sending/receiving. <Send/Receive/Polling/Bulletin
board>
Memory over during reception. <Receive/Polling>
Print is not made during reception in acting reception inhibit.
<Receive/Polling>
The send data length of one page exceeds the limit (2m) in sending.
<Send/Bulletin board>
The receive data length of one page exceeds the limit. <Receive/Polling>
Speaking before data transmission
A document jam occurs in direct sending. <Send>
The FAX signal from the remote party is not detected within T1 time.
<Send/Polling> (When in recall, however, the recall setting in case of a
communication error is valid.)
A decode error occurs in the FAX board. <Send/Bulletin board>
OK Normal end of communication
OK in Internet FAX send with reception confirmation.
The called side does not have polling function in polling reception. <Polling>
The called side has no data to send. <Polling>
In polling reception, DCN is received for DTC. <Polling>
In polling sending, there is no send data. <Bulletin board>
In poling sending, the allow number is not matched. <Bulletin board>
In polling sending, the system number is not matched. <Bulletin board>
In confidential sending, the remote party does not have confidential function.
<Send> (Including other company's machines)
1) The NSF signal has not "Confidential function" bit.
2) The NSF is not a Sharp machine.
In confidential reception, a confidential box number which is not registered is
specified.
In relay command sending, the remote machine has no relay function.
<Send> (Including other company's machine)
1) The NSF signal has not "Confidential function" bit.
2) The NSF is not a Sharp machine.
1) In relay command sending, DCN is received for NSS. <Send>
2) In relay command reception, a remote station number which is not
registered is specified. <Receive>
3) In F code relay broadcasting, an F code relay command is
received.<Receive>
In relay command reception, the relay ID does not match. <Receive>
Communication Interruption Content
SHARP