Sharp MX-2640N Technical Manual page 50

TEST SIMULATION
55 MFP Data Setting
3 Controller soft switch setting:-
SW29-7 Disable Pop Up Message for Data
is being cleared (DSK) & Settings
of machine changed by Web
page:-
0 = Displayed (Default)
1 = Not displayed
SW30-3 Hold Image Send destination
address function.
0 = Disabled,
1 = Enabled (Default)
SW33-4 90 degrees rotate from the
Bypass Tray when Size Input is
set to "X=148 / Y=210
0 = Disabled, 1 = Enabled
10 Special Stamp setting (Taiwan only)
56
MFP Data Import & Export
1 Transfer data execute (MFP/SD Card/SRAM
& EEPROM)
2 Export/Import EEPROM/SD Card/HDD data
3 Document filing data backup to USB
4 Job log data backup to USB
5 Export Adjustment & Settings data to USB
6 Output Jam/Trouble data
7 Export Syslog data to USB
60
Memory Operation & Test
1 SDRAM read/write test (MFP PWB)
61
LSU Writing Adjustment/Test
1 LSU test (Polygon & BD detection check)
3 LSU power auto setup
4 LSU position adjustment (CMYK)
11 LSU power correction (automatic)
12 LSU power manual correction
13 LSU power correction value reset/clear
62
HDD Operation & Test
1 HDD/SD Card format
2 HDD partial read/write check
3 HDD read/write check (all areas)
6 Smart (HDD) self diagnostic test
7 Smart (HDD) self diagnostic error log
8 HDD/SD Card format (excluding system &
operation manual area)
10 Job completion list deletion (with job log)
50
62 HDD Operation & Test
11 Document filing data deletion
12 Enable/disable auto format for HDD
trouble.
13 HDD format (manual area only)
14 Delete document filing management data
20 Check operation of mirroring hard disk
63
CCD Operation & Adjustment
1 Shading correction data display
2 Shading correction execution (force)
3 CCD gamma & colour correction adjust.
4 SIT chart patch density list display
5 CCD gamma & colour correction reset.
6 Print engine colour balance
7 Standard target colour calibration set-up
8 Standard scanner target reset (Service)
11 Colour Balance setting (Factory Mode).
64
Self Test Print
1 Test print (Colour mode)
2 Test print (B/W mode)
4 Printer self print test
5 Printer self print test (PCL)
6 Printer self pint test (PS)
7 Adjustment pattern print (Sim46-21)
65
LCD Operation & Adjustment
1 LCD touch panel adjustment
2 LCD touch panel adjustment result display
5 Operation panel key input test
66
Fax Control Settings & Adjustments
1 Fax Soft SW setting:-
SW24 Communication Signal sending
level (bits 1-8):-
Default Value (Australia/NZ)
00001011
SW27-4 V.34 mode function (call
arrival):-
0 = V.34 valid.
1 = V.34 invalid.
SW27-5 V.34 mode function (polling
when calling):-
0 = V.34 valid.
1 = V.34 invalid.
SHARP