Sharp MX-2640N Technical Manual page 10

INITIAL SETUP
PRINT IMAGE POSITION & MAGNIFICATION
Automatic Adjustment:-
Sim 50-28
Manual Adjustment:-
Sim 50-10
Sim 50-10
Sim 50-05
IMAGE SKEW & COLOUR REGISTRATION
Sim 61-04
Sim 50-22
HALF TONE COLOUR CALIBRATION
Sim 46-74
COPY IMAGE QUALITY
Check Image Quality (Copy Mode) – Density, Magnification, Lead Edge & Void.
PRINT IMAGE QUALITY
Check Image Quality (Print Mode) – Density.
Sim 64-05
Sim 64-06
10
BK MAG ADJ (Main Scan Mag).
SETUP/PRINT ADJ (Lead, Offset or All).
BK MAG (inside dimension) to 240mm.
Image Off Centre Adjustment.
Printer Lead Edge & Void Adjust.
Image Skew Adjustment (Black)
Colour Registration/Skew & OPC Drum Phase Adjustment
Check/Adjust SKEW (CMY) so value is Close to 0 as possible
(Result=OK).
Engine & Printer Colour Calibration
If NG, perform the following adjustments as required:-
Sim 46-01
Sim 46-02
Sim 46-09
Sim 50-28
Manual Adjustment (Magnification, Lead Edge, Void, Off Centre etc).:
Sim 48-01
Sim 50-01
Sim 50-12
PCL Density Test Page
PS Density Test Page
Select A3 Paper.
Copy Density Adjust. (Colour).
Copy Density Adjust. (B/W).
SPF Copy Density Adjust.
OC ADJUST (Lead, Offset & Mag).
SPF ADJ:(Lead, Offset & Sub scan).
Magnification Adjustment (OC & SPF).
Lead/Rear Edge, Loss & Void Adjust.
OC & SPF Off Centre Adjust.
Select FACTORY Mode.
SHARP