Sharp MX-2640N Technical Manual page 59

SHARP
Report Code
Result Displayed
(Result)
NG95 XXXX *1
95
NG96 XXXX *1
96
NG98 XXXX *1
98
NG99 XXXX *1
99
*1 For a job status result in "Display in the column of result, NG
code number. For a communication result, Communication error
*2 The error code of Scan To USB is specified only in the job log.
* When the communication result is OK, the communication sub code 1 and the communication sub
code 2 are 0000. Errors in ( ) are not used.
COMMUNICATION REPORT SUB CODE 1:
The communication report sub code 1 (upper 2 digits) are always indicated as 00.
COMMUNICATION REPORT SUB CODE 2:-
Report Code 2
00
01
02
03
04
05
06
07
08
09
10
11
12
13
14
15 In V.34 mode, time up is generated when shifting from Primary to Control.
16 In V.34 mode, time up is generated when shifting from Control to Primary.
17
18
19
20
21
22
23
24
25
26
In V.34 mode, time up is generated when shifting from Primary to Control.
27 In V.34 mode, time up is generated when shifting from Control to Primary.
When sending the FSK signal, no response of send completion is sent back from
28
IMAGE SEND COMMUNICATION ERROR
When the path is too long in execution of Scan To USB.
When the normal process is not executed in the secure mail sending.
The copy inhibit pattern is detected when scanning a document.
A document which is inhibited to be copied such as a banknote is scanned.
Communication Interruption Content
When the conditions after 01 do not apply.
Carrier detection time up
Time up of the communication start command from the machine side
Time up in phase C (8 min)
Memory image decode error
Memory image decode error
Time up between frames in phase C (Report code is 0 or 16.)
Polarity reversion detection
Invalid command reception
Time up (1-minute timer/6-second time)
Command receive time-up from MFP controller
Polarity reversion detection
Invalid command reception
Fall-back retry number over
Command retry number resend over
Time up (T5 timer) in V.34 mode
the MODEM chip within a certain time. (V.34, other than V.34)
Communication Interruption Content
Send length over
EOL time up
Not used
Not used
PUT error
Not used
Not used
Time up (T5 timer)
XXXX is displayed,
(XXXX) is displayed.
Send / Receive
Send/Receive
Receive
Receive
Receive
Receive
Send/Receive
Receive
Receive
Receive
Receive
Receive
Receive
Receive
is the
Send
Send
Send
—
—
—
—
Send
Send
Send
Send
Send
Send
Send
Send
Send
59