Troubleshooting; Troubleshooting Guide - Dualit Cafe Cino Instruction Manual & Guarantee

CLEANING
- AFTER EACH USE
7
6 MILK CONTAINER
Empty the Milk Container For a more thorough clean,
and clean with warm, soapy remove the Steam Wand
water and rinse. Note: You from the Milk Container Lid
can rinse the Steam Wand and pull the metal coil off
through the steam inlet whilst the Whisk. Rinse the Steam
attached to the Lid. Note: Wand through to flush out
these are not suitable for any milk residue and clean
the dishwasher. the Whisk components fully.
9 RE-ATTACH
10
Dry and then push the metal Note: The Capsule Basket,
coil back onto the Whisk. Drip Tray & Water Tank are
Align the pip on the Steam diswasher safe. Wash cycle
Wand with the groove in the below 40
Lid to re-attach. rack only & remove prior to
drying cycle. Do not wash
any other parts in the
dishwasher.
8
RINSE WIPE LID
Wipe down the Milk
Container Lid with a damp
cloth. NOTE: If the Lid is
submerged in water, ensure
water is completely drained
from the Lid. Note: this
is not suitable for the
dishwasher.
DISHWASHER 11 WIPE DOWN
& STORE
40 C
TOP RACK
ONLY
Wipe down the body
and Nozzle of the capsule
machine with a damp, non-
C. Put on top
O
abrasive cloth. Dry all parts
before assembling back
together and storing.
22

TROUBLESHOOTING

GUIDE
IMPORTANT NOTICE: PRODUCT FAILURE DUE TO THE BUILD UP OF LIMESCALE IS NOT
COVERED BY GUARANTEE - DESCALE REGULARLY.
POSSIBLE CAUSE(S)
THE CAPSULE MACHINE DOES NOT TURN ON
The unit may not be properly
connected to the power supply.
THE CAPSULE MACHINE IS NOT DISPENSING TEA OR COFFEE
The Coffee or Tea Buttons illuminate
without flashing, but no tea or coffee is
dispensed.
You may have run out of water.
The Water Tank may not be seated
correctly.
Nespresso ® trademark is owned by Société des Produits Nestlé S.A
TO REPLACE FUSE,
REMOVE SILVER LABEL
TO ACCESS SCREW.
SOLUTION(S)
1. Check the plug is in the socket and the switch is
turned on.
2. Check and replace the fuse if necessary. Note: in
order to open the plug, remove the label to reveal
the screw.
3. The machine may be in Standby Mode, which
activates automatically after 10 minutes. In this
Mode the tea and coffee lights turn off to conserve
energy. You can exit Standby Mode by pressing
any Button.
1. The Nozzle could be blocked. Follow the
Cleaning instructions on page 21. If this does not
clear the blockage refer to page 19 to descale your
machine.
2. The inserted capsule could be faulty. Wait a
few moments before opening the Lever, flush the
machine through and then try again with another
capsule.
3. Ensure that the Lever is properly closed and the
Capsule Basket is empty.
4. There could be air trapped in the pipework.
Remove the capsule and ensure that the Water
Tank is full. Press the Coffee or Tea Button. Water
should exit the Nozzle. If it doesn't, press again to
release the trapped air.
Remove the Water Tank and fill with fresh water.
Position by aligning the connection and pushing down
firmly. Tip: Bubbles rise in the Water Tank when it
is correctly seated. Then push the Water Tank Lid
down to cover the Water Tank.
23