THORLABS PM320E Operation Manual page 4

3.6 Statistics Mode
3.7 Chart Mode (Power Sensors)
3.8 Histogram Mode (Energy Sensors)
3.9 System Configuration
3.10 Analog Output
3.11 Miscellaneous Analog Output
4 Remote Operation
4.1 Connecting a Computer
4.2 PM320E Utility Software
5 Command Reference
5.1 Common IEEE488.2 Commands
5.2 Measurement Commands
5.3 Device Setup Commands
5.4 Sensor Commands
5.5 MISC-Output Commands
5.6 Device Status Commands
5.7 General System Commands
5.8 Status Reporting
5.9 Error Reporting
6 Measurement Considerations
6.1 Choosing the Right Sensor
6.2 Reducing Noise for High Accuracy Measurements
6.3 Power Measurement of Pulsed Signals
6.4 Line Width of Light Sources
6.5 Temperature Effects on Thermal Sensors
6.6 Ambient and Stray Light
6.7 Back Reflection
6.8 Beam Diameter vs. Active Sensor Area
6.9 Fiber Based Measurements
7 Maintenance and Service
7.1 Line Voltage Setting
7.2 Exchange Mains Fuses
7.3 Firmware Update
7.4 Troubleshooting
8 Appendix
8.1 Technical Data
8.2 Pin Assignment of the Sensor Connector
8.3 Certifications and Compliances
8.4 Warranty
8.5 Copyright and Exclusion of Reliability
23
23
24
24
24
25
26
26
26
28
28
30
34
42
43
47
49
51
52
54
54
54
54
55
55
55
55
56
56
57
57
58
59
60
61
61
63
64
65
66