Mitsubishi Electric MR-B46Z-W-C Service Manual page 63

OPERATING PROCEDURE
8. Compressor cover
Compressor cover
(1) Remove the 8 screws for compressor cover on the back of the
refrigerator. (See photo 43.)
Drain pan
(2) Remove the screw. (See photo 44.)
Caution
Wash the drain pan with water when it is dirty.
In case water is accumulated in the drain pan, be careful not to
spill the water.
(3) Remove the drain pan while bending the pipes inside the drain
pan upward.
Note:
Avoid crushing the pipes.
Box fan
(4) Pull out the box fan by removing the fixing screw (See photo 45)
and the connector.
Note:
Route the wiring as shown in photo 46.
(5) Install the condenser in the reverse order of removal.
Bend the pipes in the drain pan downward as they were before
disassembly.
Note:
Provide a clearance of 10 - 15 mm between the piping and the
sides of the drain pan.
OAH162
Drain pan Box fan
Photo 43
Photo 44
Drain pan
Photo 45
Connector
Photo 46
63
PHOTOS
Screws
Compressor
cover
Screws
Screws (Drain pan)
Box fan
Compressor
Screw(Box fan)
Charge pipe