Mitsubishi Electric MR-B46Z-W-C Service Manual page 56

OPERATING PROCEDURE
Cover (Ice maker)
(8) Remove the screw and 2 connectors. (See photos 20, 21.)
Ice tray lock lever
(9) Turn the ice tray lock lever 45 degrees as shown in Figure 12.
Slide the lever to the right to remove it.
Ice tray
(10) Pull out the ice tray.
Figure 12
Automatic ice maker assembly
(11) Remove the water supply pipe from the refrigerator compart-
ment side.
(12) Insert your hand into the opening where the connector was
placed. (See photo 21.) While pushing the tab on the upper left
side of the automatic ice maker downward, pull out the auto-
matic ice maker toward you. (See photos 20, 21.)
Ice maker thermopile
(13) Remove seal tapes for lead wire fixing (3 places) and for ther-
mopile substrate waterproofing (1 place). (See Figure 13.)
Press to disengage a tab (1 place) on top of the cover of the
ice maker thermopile from behind (ice making tray side), and
remove the ice maker thermopile. (See figure 14.)
Figure 14
OAH162
Slide to the right.
Upper tab on ice maker
thermopile cover
Photo 20
Connector
Screw
Ice tray
The Ice maker thermopile is taped in place on the
body of the automatic ice maker.
Photo 21
Insert a hand.
Connectors
Figure 13
Substrate
waterproofing tape
Sealing tape for
lead wires
56
PHOTOS
Ice tray lock
lever
Automatic ice
maker assembly
Tab
Automatic ice
maker assembly
Ice tray lock
lever