Mitsubishi Electric MR-B46Z-W-C Service Manual page 53

OPERATING PROCEDURE
2. Parts inside the refrigerator compartment: Connector
box Screw cap
LED Cover of water supply pump motor
switch for refrigerator compartment, ice making com-
partment and versa compartment.
(1) Remove the parts in the refrigerator compartment.
Connector box
(2) Remove the screw . Pull the connector box towards you
as shown in photo 8, and disconnect the 2 connectors that
connect to the control panel, then remove the connector box.
(See photos 7, 8.)
Photo 8
Screw cap
(3) Disengage the tabs beneath the lower parts of the screw
caps with a precision flat-blade screwdriver, and remove the 2
screws. (See photos 9, 10.)
Photo 9
Screw caps
Control panel
Duct R
(4) As shown in the photo 11, hold the both right and left sides of
the control panel, and pull towards you.
Caution on assembly
To prevent poor contact of connectors, connect them properly.
Fix the control panel by inserting the lower tabs (2 places) into
the bottom of refrigerator compartment.
Note:
The following parts are integrated in the control panel: duct R,
motor damper for refrigerator compartment, refrigerator com-
partment thermistor, chilled thermistor and damper cover.
Interior LED
(5) Remove the screw, and slide the interior LED toward back to
disengage from the center front tab and 4 tabs on left and right.
Disconnect the connectors. (See photo 12.)
Caution on assembly
Do not pinch the lead wires and connector in the cover when
attaching it.
OAH162
Control panel, Duct R
Photo 6
Interior
Door
Photo 7
Cover of water
supply pump motor
Photo 10
Photo 11
Photo 12
Ceiling of refrigerator compartment
Tabs
53
PHOTOS
Control panel
Connector box
Cover of water
supply pump motor
Connector box
Screw
Screw caps
Tab
Interior LED
Screw
Tabs