Mitsubishi Electric MR-B46Z-W-C Service Manual page 54

OPERATING PROCEDURE
Cover of water supply pump motor
(6) Remove the screw, and lift the cover of water supply pump
motor, then disconnect the connector. (See photo 13.)
(7) Cut the lead wires from the cover of the water supply pump
motor (See figure 10.), then pull up the lead wires to be
removed from the cover of the water supply pump motor. (See
photo 13.)
(8) Remove 2 screws inside the cover of the water supply pump motor,
then remove the water supply pump motor. (See photo 14.)
Photo 14
Water supply pump motor
Caution on installation
Connect the water supply pump motor for service with the con-
nector as shown in the figure 11.
When mounting the water supply pump motor for service,
attach 2 screws to the cover of the water supply pump motor.
Note:
• Securely fit the cover of the water supply pump motor so as not
to form any clearance.
• Enclose the lead wires neatly to prevent them from tangling in
the groove.
Door switch for refrigerator compartment,
ice making compartment and versa compartment
(9) Insert a flat-blade screwdriver between the refrigerator body
and the switch.
OAH162
Cover of water
supply pump motor
Screws
Photo 13
Cover of water
supply pump motor
Figure 10
Mirror hinge
Cover of water
supply pump motor
Figure 11
Lead wires cut
in figure 10
(body side)
Mirror hinge
Water supply pump motor (For replacement)
Make sure to clear away any dust such as
iron dust.
54
PHOTOS
Air path
Screw
Water supply pipe
White
Red
Backside
connector
White
Red