Chapter 3: Operation; Figure 5 Configuration Menu - Raritan MCIP18 User Manual

C 3: O
HAPTER PERATION

Chapter 3: Operation

Use the Configuration Menu is to specify your MCIP configuration and to set or change operation
parameters.
Activate the On-Screen User Interface (OSUI) by pressing the Hot Key (default: Left CTRL
1.
key on keyboard) three times rapidly. When the OSUI appears, press F4 to access the
Configuration Menu.
Note: Currently, Hotkey function is not enabled for further change.
The Connected field displays the Channel ID and Name of the currently selected
a.
computer.
The Model field displays the model number of this MasterConsole unit.
b.
Use the Tab (forward)/Shift + Tab (backward) keys to highlight the desired field and make
2.
your changes as follows:
To change Name (default is the unit's model number): Move to Name and type a name
a.
up to seven characters. This field is used for identification purposes only.
To turn AutoScan ON/OFF (default is OFF): Move to Scan and press the
b.
toggle. If you exit the OSUI with AutoScan ON, MCIP will scan according to the
currently set mode (Individual/Global) and scan rate.
To change the Global Scan Rate (default is 3 seconds): Move to Set and type a
number from 01 to 99, or press the
for Global AutoScan.
To change AutoScan mode (default setting is Global): Move to Mode and press
the / keys to toggle between Global and Individual.
To turn AutoSkip ON/OFF (default is OFF): Move to Skip and press the
c.
toggle. With AutoSkip ON, only active channels can be selected.
To change the ID Display time interval (default is 3 seconds): Move to ID Display and
d.
type a number from 01 to 99, or press the
you want the Channel ID and Name to display when each computer is selected. Type 99
if you want the Channel ID and Name to display continuously.
Green mode is disabled.
e.
Previous channel key function is disabled.
f.

Figure 5 Configuration Menu

/ keys to specify the Scan Rate (in seconds)
/ keys to specify the interval (in seconds)
5
/ keys to
/ keys to