E69: Washing Heating Element Interrupted (Version Wd) - Electrolux EWM25 series Service Manual

E69

E69: Washing heating element interrupted (version WD)

Checks to perform:
Measure the heating
element value (Ω) across
terminals J6-2 ÷ J6-1 of the
wiring connector.
– (see fig. 4) –
Is the value correct?
(26÷28Ω for 230V/1950W,
28÷31Ω for 240V/1950W)
YES
Replace the WD board and
restart the diagnostic cycle
to check for further alarms.
Fig.13
26÷28Ω 230V 1950W 26÷28Ω 230V 1950W
28÷31Ω 240V 1950W 28÷31Ω 240V 1950W
07-2010 SOI/DT-mdm FCPD-dp Quality-fz
Check that all the connectors are inserted correctly
Measure the ohmic value
directly on the terminals of
NO
the heating element (detach
the connectors)
– (see fig 13) –
Is the value correct?
(26÷28Ω for 230V/1950W,
28÷31Ω for 240V/1950W)
Controllare/sostituire il
cablaggio e riavviare il ciclo
diagnostico per verificare
ulteriori possibili allarmi.
NO
YES
Fig.4
WD
board
If there are traces of burning on the
circuit board, refer to pages
79/121
Replace the heating
element and restart the
diagnostic cycle to check
for further alarms.
J4 J6
Fig. 29
J1 J7
26÷28Ω 230V 1950W
28÷31Ω 240V 1950W
599 70 99-00
E69
J5
J8
119-120