Troubleshooting According To Alarm Codes; E11: Difficulty In Filling Water During Washing Phase - Electrolux EWM25 series Service Manual

7 TROUBLESHOOTING ACCORDING TO ALARM CODES

E11: Difficulty in filling water during washing phase

E11
Checks to perform:
NO
Access the diagnostic cycle and duct water through all the compartments (phases 2,3,4,5)
Is the drain hose positioned
correctly so as not to create the
siphon effect? (fig. 1)
Is the hydraulic circuit efficient
Is the hydraulic circuit of the
pressure switch efficient
(leaks/blockage)? (fig. 2)
Replace the circuit board and restart the diagnostic cycle to check for further alarms.
Do any or all the solenoids fail to function?
Is the ohmic resistance of the solenoid about
3.5 ÷4.5 KΩ? (Measure directly on the solenoid
valve without wiring). – (see fig. 3) -
Re-attach the connector and measure about
3.5 ÷4.5 KΩ on the solenoid wiring connector
(circuit board side (fig. 4):
across J9-3 and J9-1 (wash),
across J9.4 and J9.6 (prewash),
across J8-3 and J8-1 (bleach).
Is the solenoid valve wiring OK?
Replace the circuit board and restart the
diagnostic cycle to check for further alarms.
07-2010 SOI/DT-mdm FCPD-dp Quality-fz
Maximum water fill time for each pressure switch level
(this time is reset to zero each time the level is reached)
Check that all the connectors are inserted correctly
Is water ducted through all the compartments?
YES
YES
(leaks)?
YES
YES
YES
YES
YES
NO Position the drain circuit correctly and restart the
diagnostic cycle to check for further alarms.
NO
Repair the hydraulic circuit and restart the
diagnostic cycle to check for further alarms.
NO
Repair the hydraulic circuit of the pressure
switch and restart the diagnostic cycle to check
NO Check that the tap is open, that the mains
water pressure is sufficient and that the hoses
are correctly connected and not kinked.
NO
Replace the solenoid and restart the diagnostic
cycle to check for further alarms.
NO
Replace or repair the wiring and restart the
diagnostic cycle to check for further alarms.
If there are traces of burning on the circuit
board, refer to pages
24/121
for further alarms.
119-120
E11
599 70 99-00