E69: Washing Heating Element Damaged - Electrolux EWM09312 Service Manual

E69
Checks to perform:
Measure the resistance
value of the heating
element () between
terminals J6-1 ÷ J6-2 of the
wiring connector
(see fig. 4)
Is the value correct?
(28÷31 for 230V/1750W)
Y
E
S
Replace the circuit board
and repeat the diagnostic
cycle to check for any
further alarms.
Fig. 13
28÷31Ω 230V 1750W
2012 SOE/DT-mdm FCPD-dp
Guide to diagnostics of EWM09312 electronic controls

E69: Washing heating element damaged

Measure the resistance
value directly on the
terminals of the heating
(detach the connectors)
NO
(see fig. 13)
Is the value correct?
(28÷31 for 230V/1750W)
Check/replace the wiring and repeat the diagnostic cycle to check
General earthing
connection
Washing heating
element
!
Check that all the connectors are correctly inserted
element
NO
Y
E
S
for any further alarms.
J14 J5
J4
GND
Fig. 4
28÷31Ω 230V 1750W
!
53/69
Replace the heating
element and repeat the
diagnostic cycle to check
for any further alarms.
J11 J13 J10
J6
MAIN CIRCUIT
BOARD
If there are burns on the circuit board,
see page 67
599 75 18-74 Rev.00
E69
J8 J7