Troubleshooting Based On Error Codes; E11: Fill Time Too Long - Electrolux EFLS617SIW Technical & Service Manual

E11: Fill Time Too Long

E11
Water Tap closed, Water Flow Rate too low, Pressure Sensor defective, Inlet Valve
defective or Air Tube kinked.
Checks to perform:
Run the diagnostic cycle test, and check if hot and cold inlet valves are working?
Is the drain pipe positioned correctly and not causing the
N
O
Is the incoming water pressure above 20 psi?
Is there any kinked or blocked incoming water hoses?
Is the Pressure Sensor air tube connected properly
without kinking and leaking? (Disconnect the tube, and
blow to ensure no obstruction.)
Is the frequency of Pressure Sensor between 44.5 Hz
to 45 Hz? (Measure it on the Pressure Sensor wiring
connector at Main Control Board when machine is
powered with empty tub (No water).) (See Fig. 2)
Remove the power from the Washer. Did the water fill
See Next
Page
Replace the Main Control Board, and repeat the diagnostic cycle to check for any further errors.

14. Troubleshooting Based on Error Codes

Y
E
S
siphon effect? (See Fig. 1)
Y
E
S
Y
E
S
N
O
Y
E
S
Y
E
S
stop?
N
O
WARNING
Check that all the connectors are correctly
inserted.
Repair the drain circuit, and repeat
the diagnostic cycle to check for any
NO
Correct the pressure problem in the
customer's place and repeat the diagnostic
NO
cycle to check for any further errors.
Repair the incoming hoses and repeat
the diagnostic cycle to check for any
YES
Repair the air hose on the pressure
NO switch, and repeat the diagnostic
cycle to check for any further errors.
Replace the Pressure Sensor, and
repeat the diagnostic cycle to check
NO
Replace the Pressure Sensor and
repeat the diagnostic cycle to check
YES
35
E11
further errors.
further errors.
for any further errors.
for any further errors.