Since the early 1900s, Monark’s cycles have been living proof of precision, re- liability, strength and service. That are the reasons why we are now the world leader in cycle ergometers and the market leader in Scandinavia in transport cycles.
Congratulations on your new Recumbent. • Easy entrance and stable saddle • Wheels for easy transport Monark Cardio Comfort 837 E is designed to be used • Stable frame, solid steel tube for exercise and rehabilitation. This model is perfect •...
2) Tension knob that it locks (a ”click sound”). The back support can also be adjusted up and down to a comfortable posi- tion by loosing the knob(2). See fig: Adjustments. Fig: Adjustments 1) Catch 2) Locking knob Monark 837 E...
SET key will advance time by one minute. pulse limit individually. If you hold down the button for more than two seconds at normal display, all val- ues except upper and lower pulse limit will be set to zero at the same time. Monark 837 E...
837-007.ai Do not expose the fitness computer to direct sunlight or extremely high temperature. Do not use any dis- Fig: Batteries pulse sensor solvents when cleaning. Use only dry cloth. 837-015.ai Monark 837 E...
Scratching noise is heard when pedalling. Check that the carriage block is taken off and that none of the covers is scratching. There is a click noise and a squeak noise Untighten the chain a bit. when pedalling. Monark 837 E...
(4 times EC Directive 1999/44/EC. In short, the directive pro- per year). vides for that your Monark Dealer will be liable for • Check now and then that both pedals are firmly any defects, which existed at the time of delivery.
The crank bearing is long term greased and require normally no supplementary lubrication. If problem Brake belt contact surface arises, please contact your Monark dealer. Deposits of dirt on the brake belt and on the contact Flywheel bearing surface may cause the unit to operate unevenly and will also wear down the brake belt.
The sprocket should be lubricated with a few drops of oil once a year. Tilt the cycle somewhat to make it easier for the oil to reach the ball bearing. See fig: Lubrication. Fig: Lubrication Fig: Hub assembly Fig: Special remover (Art. No: 9100-14) Monark 837 E...
Need help?
Do you have a question about the 837 E and is the answer not in the manual?
Questions and answers