Mibs; Standard Mibs - Nortel SR1001 Installation Manual

MIBs

Secure Routers support standard and enterprise MIBs. The following tables provide information
about supported MIBs.
Table 32 Standard MIBS
Standard MIB Description
RFC 1213 Standard MIB-II objects.
The following groups or variables are not supported for this MIB:
egp
n
at
n
RFC 1315 MIB objects for frame relay DTE interface.
The following SNMP SET operation variables on frDlcmiTable are not supported for this MIB:
frDlcmiAddress
n
frDlcmiAddrsssLen
n
frDlcmiMaxSupportedVCs
n
frDlcmiMulticast
n
RFC 1403 Defines the interoperability of using BGP as the border gateway routing protocol and OSPF as
the interior gateway routing protocol.
RFC 1406 MIB objects for DS1 interface.
The following Far End tables are not supported for this MIB:
dsx1FarEndCurrentTable
n
dsx1FarEndIntervalTable
n
dsx1FarEndTotalTable
n
RFC 1643 MIB objects for Ethernet-like interface.
The following variables are supported for this MIB:
dot3StatsFCSErrors
n
dot3StatsDeferredTransmissions
n
dot3StatsFrameTooLongs
n
The remainder are not supported.
RFC 1657 Describes MIB objects used for BGP4 routing protocol.
RFC 1724 Describes MIB objects used for RIP routing protocol.
RFC 1850 Describes MIB objects used for OSPF routing protocol.
RFC 1997 Facilitates and simplifies the control of routing information. This rfc suggests a grouping of
destinations so that the routing decision can also be based on the identity of a group.
RFC 2096 Describes objects used for the display of CIDR multipath IP routes.
RFC 2233 MIB objects for interface table extensions including StackTable and ifXTable. IfStackTable
shows the sub-layer relationships of interfaces.
The following groups or variables are not supported for this MIB3:
ifTestTable
n
ifRcvAddressTable
n
In the ifXTable, all High Counters (HC)(ifHC***) variables requiring 64-bit counters are
n
not supported.
RFC 2787 Describes MIB objects used for managing Virtual Redundancy Protocol (VRRP) routers.
63
SR1001 Installation Guide
Version 8.3.5