Changing Login Parameters; Password; Administrator Account; Secure Router Host Name - Nortel SR1001 Installation Manual

Changing Login Parameters

Password

Administrator Account

Secure Router Host Name

The System Administrator login consists of two components: the user name and the password.
The initial login name is always Admin, but you can change this to suit your needs after
logging in for the first time. The default password, Setup, should be changed as soon as
possible to ensure only authorized access to the router.
For more information about command usage for serial and T1 products, refer to the Command
Reference Guide. This guide is available on the Nortel website: www.nortel.com.
This procedure enables the system administrator to change any or all user passwords, or any
user to change their password on the SR1001. The password must be 3-10 characters.
To change the password:
1 Access the password configuration mode.
example:
SR> password
The Secure Router prompts for the current user name.
2 Type Admin, and then press Return.
The Secure Router prompts for the old password.
3 Type Setup, and then press Return.
The Secure Router prompts for the new password.
4 Type your new password, and then press Return.
The Secure Router prompts you to verify the new password.
5 Type the new password again and then press Return.
A message is appears confirming that the password has been changed.
This procedure changes the administrator login name (Level 1 access) to a user-specified
name. The default is Admin.
To change the account name:
1 Access the configure mode.
example:
SR>
configure term
2 Change the account name.
example:
Nortel/configure>
admin_name Greg
This example above changes the Level 1 user name to Greg.
The Secure Router displays a confirming message: "Administrator account name changed to Greg."
Changing the administrator login name does not change the administrator's password. Use the
NOTE:
password procedure to change the password.
Use the configure hostname command to assign a host name to the Nortel router. Once
assigned, the host name becomes the command line interface (CLI) prompt name.
29
SR1001 Installation Guide
Version 8.3.5