Table of Contents
Advertisement
M A G I C
A D 1
E T I
P A G E 7 4
M u l t i
S o f t w a r e
FIG. 48
A green LED next to the system name shows that the connection is ok and that
no alarms have ocurred.
If the LED is displayedin blue, an alarm has been ocurred.
A red LED shows a current alarm or a faulty PC connection.
If you double-click on the system name or the LED, the System Monitor is
displayed.
If you click on the system name or the LED with the right mouse key, you can
select if you want to open the System Monitor (Open System Monitor) or
open the configuration dialogue (Open Configuration Dialogue).
The tree structure with parent nodes (e.g. ETI Master in Fig. 48, Page 74) and
child nodes (e.g. Decoder 1, Decoder 2 and Decoder 3 in Fig. 48, Page 74)
can be created by using the following name structure under System name
(see Page 43) in the configuration:
Example:
Add a MAGIC AD1 ETI Decoder to the control list
To add a new system, click on the Add/Edit button in the Control Port Set-
tings window (Fig. 46, Page 73). The window for the Communication Inter-
face Parameters is displayed. Please select the option LAN under Interface.
FIG. 49
Under Parameter
one network interface card in your PC, select the desired one.
The standard IP Address of the system is 192.168.96.102 and the standard
control Port 10000.
To enable a connection with your PC, you have to be in the same subnet.
Therefore, please enter an IP address from your subnet
1
In this way you can find out your own subnet: Under Windows XP click on Start → Execute ....
Enter cmd in the command line. An entry window is displayed in which you must enter ipcon-
fig. Your IP address is displayed (e.g. 192.168.12.35). Your subnet is accordingly 192.168.12.xxx.
DETAILED VEW OF TREE CONTROL LIST
Name of parent node - Name of Child node
ETI Master - Decoder 1
LAN PARAMETERS
→
Interface edit <Default>. If there should be more than
1
.
Advertisement
Table of Contents
