Restoring Configuration Information - Hitachi VisionBase 8880R Product Manual

Restoring Configuration Information

When you change ICU settings and exit the ICU, the newest configuration information is saved as the file name
"SYSTEM.IMG". When the configuration information has been destroyed or when you want to set up the system
equipment again, you can use the SYSTEM.IMG file to restore the configuration information.
Reset the setup contents of the system equipment to the factory-set status, or set up the system equipment once
1.
again.
If the configuration information has been destroyed, the contents of the Setup Menu must be returned to the
factory-set status.
Before setting up the system equipment again, remove all boards other than those already installed as standard
boards.
Start the ICU.
2.
In the [ISA Configuration Utility] window, choose the [Advanced] menu.
3.
A screen that looks like the following is displayed. On that screen, choose [Load Image...].
4.
In the [Load Image File] window now displayed, choose "a:" from [Drives:] and "SYSTEM.IMG" from
5.
[Filename:]. The SYSTEM IMG file in ICU DISK2 in drive A restores the configuration information.
If you keep on operation after an image file is called, a malfunction might occur.
Be sure to exit the ICU and then restart the system equipment.
6.
Hitachi VisionBase 8880R Server
ISA Configuration Utility
File Configure View Advanced Help
Add Remove Modify View
Locking Enabled
Card Configured In System:
Lock/Unlock Card
Motherboard System Devices
Lord Image...
PCI Card: VGA Controller
Save Image
PCI Card: SCSI Controller
Save Image As...
PCI Card: Unknown Card
PCI Card: IDE Controller
Load Image File
[ ]
a:
Ch 2: System Environment Setting
47