Table of Contents
Advertisement
Ch 2: System Environment Setting
Network server
Specify whether or not to check for keyboard at the time of system startup. Leave the default setting "Disabled" as is.
•
Disabled (default)
•
Enabled
System Information
Information about the system equipment is displayed.
System Memory, Extended Memory
The memory capacity recognized at startup is automatically displayed.
NOTE: If the memory capacity displayed is less than the actual memory capacity, contact the maintenance
personnel.
What You Can Do on the Advanced Menu
Reset Configuration Data
Used to specify whether or not to clear the configuration data. Be sure to leave the default setting "No" as is.
•
No:
Not to clear (default)
•
Yes:
To clear
Execute ROM Diagnostic (Unsupported)
Used to specify whether or not to conduct initial diagnosis for ROM. Be sure to leave the default setting "No" as is.
•
No:
Does not conduct initial diagnosis (default).
•
Yes:
Conducts initial diagnosis.
NOTE: "Reset Configuration Data" and "Execute ROM Diagnostic" are used solely for maintenance purposes.
These two areas shall not be changed. Hitachi PC assumes no responsibility for any failures or
inconveniences caused by changed values in these areas.
28
PhoenixBIOS Setup Utirity
Main
Advanced
Security
Boot
Reset Configuration Data
Execute ROM Diagnostic
PCI Configuration
I/O Device Configuration
Console Redirection
Ext MP Configuration Table
I/O APIC Mode:
Enable memory gap:
PCI Data Parity:
Standard Memory Test:
WinNT 4.0 Install Mode:
Caching Above 4GB:
Large Disk Access Mode:
Disk Write Cache:
Spealer volume:
USB Controller:
↑↓ Select Item
F1
Help
-/+
←→ Select Menu
ESC Exit
Enter Select
Figure 21 Advanced Menu Screen
Exit
Item Specific Help
[No]
[No]
[Disabled]
[Single]
[Disabled]
[Enabled]
[Enabled]
[Disabled]
[Disabled]
[DOS]
[Enabled]
[High]
[Enabled]
Change Values
F9 Setup Defaults
Sub-Menu
F10 Save and Exit
Hitachi VisionBase 8880R Server
Advertisement
Table of Contents
