How To Collect Data At Certain Time Intervals [Interval Mode] - Kanomax Anemomaster 6162 Operation Manual

3. Measurement Mode

3.2 How to Collect Data at Certain Time Intervals [Interval Mode]

[POINT 1]
DATA (1)
(2) (3) ·······(N)
Time interval until the next sampling starts
Interval Time --- INT (min)
Data at each point is average value.
POINT 1···AVE 1=ΣDATA(N)/N
POINT 2···AVE 1=ΣDATA(N)/N
·
·
POINT N --- AVE H=ΣDATA(N)/N
Display
< MENU >
1. MONITOR
2. MEASUREMENT
3. DATA OUTPUT
4. MEMORY CLEAR
5. UTILITY
< MEASUREMENT >
1. AVERAGE
2. INTERVAL
3. FLOW RATE
(a)
< INT >
1. S-TIME(S) 01
2. DATA (N) 010
3. INT (min) 060
4. POINTS 024
5. MEMORY YES
6. PRINT YES
7. SET OK!
<Measurement Setting
Screen>
[POINT 2]
DATA (1)
(2)
S-TIME (S)
· ·
· ·
Key
MENU (1) Press MENU key.
(2) Select 2. MEASUREMENT.
△, ▽
SET
(3) Select 2. INTERVAL.
△, ▽
SET
(4) Set the measurement condition
△, ▽
SET
SET
(3) ·······(N) DATA (1)
Time length required to measure at one point
How long it takes to finish measuring
Calculation Result
AVE=(AVE1+AVE2+ -----AVE N)/No. of POINT (N)
MAX=AVE I, MIN=AVE J
AVE1, AVE2, ··· AVE N are stored as a data at each point.
Then press SET key.
Then press SET key.
in the same manner as when
configuring Average Mode
measurement (P14).
When the measurement condition is configured, select 7. SET
OK!, and press SET key.
[POINT N]
(2) (3) ·······(N)
S-TIME (S) × N (No. of Data)
INT (min) × No. of POINTS (N)
Procedure
☆ To select the item to be
changed
☆ To change setting value
and YES/NO.
☆ Setting is complete.
7. SET OK! ⇨ SET
16
△, ▽⇨SET
△, ▽⇨SET