Lowerable Rops Rollbar (From Serial No. Af01417 To Serial No. Ai00966); Raising/Lowering The Rollbar - Wacker Neuson 803 Service Manual

Lowerable ROPS rollbar (from serial no. AF01417 to serial no. AI00966)

P
C
A
Fig. 2: Lowerable ROPS rollbar (option)

Raising/lowering the rollbar:

SHB 803 en – Edition 2.4 * 803s710.fm
Danger
The ROPS rollbar is very heavy, folding it up and down, or lowering and raising
it, is very
Always fasten the lap belt if the rollbar is folded up.
Do not use the lap belt without the rollbar!
In case of structural damage on the rollbar, replace it immediately otherwise
S
safety is no longer ensured!
Notice!
For safety reasons, always use the ROPS bar if it is fitted on your machine.
B
Bracket P for installing a rotating beacon is located on top of the rollbar.
Raising the rollbar:
Park the machine on level ground
Stop the engine
Lock the control levers
Install suitable lifting gear on the rollbar
Remove the lock nuts and screws A on either side
Slowly and carefully raise the rollbar with suitable lifting gear and auxiliary means
Insert the screws again on either side and secure them with the lock nuts
Lowering the rollbar:
Park the machine on level ground
Stop the engine
Lock the control levers
Install suitable lifting gear on the rollbar
Remove the lock nuts and screws A on either side
Slowly and carefully lower the rollbar with suitable lifting gear and auxiliary means
Insert the screws again on either side and secure them with the lock nuts
!
Dangerous!
Use suitable lifting gear and auxiliary means to lower, raise and fold the roll-
bar up and down.
Accident hazard!
Options
7-3