Replacing The Spark Plug; Storage - Hamron 220-140 Operating Instructions Manual

5� Rinse well and allow to completely dry� Dip the filter unit in clean engine oil and squeeze out excess oil�
6� Replace the filter and the cover�

REPLACING THE SPARK PLUG

IMPORTANT:
Switch off the engine and wait until it has cooled before removing the spark plug�
1� Remove the cap from the spark plug�
2� Unscrew the spark plug with the supplied spanner�
3� Remove any coke deposits from the spark plug�
4� Check the spark gap (a) and adjust if necessary� The spark gap should be 0�7–0�8 mm�
5� Replace the spark plug, if necessary�
6� Refit the spark plug and put the cap back on�

STORAGE

BEFORE STORAGE
1� Disconnect the high-pressure hose and empty it of water�
2� Wind up the hose and hang the spray gun and head in the holders on the side of the machine�
STORAGE
Clean the machine according to the instructions and store in a clean and dry place�
LONG-TERM STORAGE
1� Switch off the engine, wait until it has cooled, and then empty the fuel tank with a pump� Collect the
fuel in a clean and approved fuel container�
GB
77