Danfoss ECL Comfort 110 User Manual, Installation & Maintenance page 2

How to navigate?
What do the symbols mean?
����
��������� � ����
����� � ���� � �������
The desired flow temperature is influenced by for example room or return temperature.
The actuator closes the control valve.
The actuator opens the control valve.
The actuator does not activate the valve.
The pump is ON.
The pump is OFF.
The controller is in setback mode.
The controller is in pre-setback mode (the symbol is blinking).
The controller is in comfort mode.
The controller is in pre-comfort mode (the symbol is blinking).
Safety Note
To avoid injury of persons and damages to the device, it is absolutely necessary to read and
observe these instructions carefully. The warning sign is used to emphasize special conditions
that should be taken into consideration.
This symbol indicates that this particular piece of information should be read with
special attention.
VI.KT.G2.02
Adjust temperatures and values.
Switch between menu lines.
Select / return.
2 sec.
Return to daily user menu.
© Danfoss 05/2007 DH-SMT/DK
Table of Contents
Introduction .................................................................................................. 6
Settings overview
Daily use ........................................................................................................ 8
Temperatures
Select control mode
Set your personal schedule
Maintenance ............................................................................................... 11
Date - time
Flow temp. (flow temperature control)
Slope
Displace (parallel displacement)
Temp. min. (flow temp. limit, min.)
Temp. max. (flow temp. limit, max.)
Room T limit (room temperature limitation)
Intgr. time (time constant for room temp.)
Gain - max. (room temp. limitation, max.)
Gain - min. (room temp. limitation, min.)
Return T limit (return temp. limitation)
Limit (return temp. limitation)
Gain - max. (return temp. limitation - max. influence)
Gain - min. (return temp. limitation - min. influence)
Intgr. time (time constant for return temp. limitation)
Priority (priority for return temp. limitation)
Optimize
Auto-reduct (setback temp. dependent on outdoor temp.)
Boost
Ramp (reference ramping)
Optimizer (optimizing time constant)
Based on (optimization based on room / outdoor temp.)
Total stop
S1 T filter (outdoor temp. filter)
Cut-out (limit for heating cut-out)
Control param. (control parameters)
Motor prot. (motor protection)
Xp (proportional band)
Tn (integration time constant)
M1 run (running time of the motorized control valve)
Nz (neutral zone)
VI.KT.G2.02
DH-SMT/DK
Line Page
1000
2000
2175
2176
2177
2178
3000
3015
3182
3183
4000
4030
4035
4036
4037
4085
5000
5011
5012
5013
5014
5020
5021
5081
5179
6000
6174
6184
6185
6186
6187
© Danfoss 05/2007
7
8
9
9
11
11
12
14
14
14
15
17
17
17
18
18
19
19
20
20
21
21
21
22
22
23
24
24
25
26
26
26
26
26
27