Honda BF75A Owner's Manual page 64

STARTING THE ENGINE (R type)
If water does not flow out, or if
steam comes out, stop the engine.
Check to see if the screen in the
cooling water intake port is
obstructed and remove foreign
materials if necessary. Check the
cooling water check hole for
clogging. If water still does not
flow out, have your outboard
motor checked by an authorized
Honda outboard motor dealer. Do
not operate the engine until the
problem has been corrected.
64
7. Check to see if the oil pressure
indicator light turns ON.
If it does not turn on, stop the engine
and perform the following
inspections.
1) Check the oil level (see page
2) If the oil level is normal and the oil
pressure indicator light does not
turn ON, consult with an
authorized Honda outboard motor
dealer.
ENGINE OIL PRESSURE
INDICATOR LIGHT
NORMAL: ON
ABNORMAL: OFF
8. Warm up the engine as follows:
Above 5°C (41°F) run the engine
for 2 or 3 minutes.
Below 5°C (41°F) run the engine
for at least 5 minutes at 2,000 min
(rpm).
Failure to completely warm up the
47 ).
engine will result in poor engine
performance.
Before leaving the dock, check the
operation of the emergency stop
switch.
−
−
-1