ZKTeco BioPro SA50 Quick Start Manual
ZKTeco BioPro SA50 Quick Start Manual

ZKTeco BioPro SA50 Quick Start Manual

Fingerprint & palm terminal

Advertisement

Quick Links

QUICK START GUIDE
BioPro SA50 Fingerprint & Palm Terminal
Time Attendance & Access Control
Version: 1.0
Date: August,2017

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the BioPro SA50 and is the answer not in the manual?

Questions and answers

Summary of Contents for ZKTeco BioPro SA50

  • Page 1 QUICK START GUIDE BioPro SA50 Fingerprint & Palm Terminal Time Attendance & Access Control Version: 1.0 Date: August,2017...
  • Page 2 1 Overview Front Side 93.0mm 45mm Fingerprint Sensor 2.4 Inch TFT LCD Keypad Door Bell & Indicator Palm Sensor 51.13mm Back Bottom Tamper Alarm Button (Power In) Speaker Ethernet Port USB Slot (Beep/ /Weigand In/ Reset Button Power Out) 6PIN (Alarm/Lock/Exit Button/ Sensor/Bell/ Auxiliary In) Star-shaped screw hole...
  • Page 3 5 Do not install the device in a place subject to direct sunlight humidity or dust 4 Wiring Diagram RS485 R 485 U Disk TCP IP Server Door Lock Sensor Wiegand Door Exit Button Printer 485 Reader Alarm Door Bell Card Reader 5 Door Bell Door 5 Door Bell Door...
  • Page 4 6 485 Reader Connection 485A 485B +12V +12V 485- 485+ 485A 485B How to enable 485 Reader Function? 1. Enable RS485 Reader Function: Press M/OK > Comm. > Serial Comm > Serial port , select [master unit]. 2. Setting 485 Reader veri cation mode: Press M/OK > Access Control > Access Control Options >Verify mode by RS485,to choose veri cation mode.
  • Page 5 8 Power Connection Description Color Ground Black Power In +12V 12V DC 12V ± 10%, at least 500mA. To share the power with other devices, use a power supply with higher current ratings. 9 Printer Connection 485A 485B 10 Communication with 10 Communication with Via Ethernet Cable Via Ethernet Cable...
  • Page 6 12 Date/Time Setting Press M/OK > System > Date Time to enter the Date Time interface. 13 Adding a User Press M/OK > User Mgt. > New User to enter the New User interface. The setting include entering a name, modifying user roles (Super Admin / Normal User), enrolling «...
  • Page 7 15 Access Control Setting Press M/OK > Access Control to enter the Access Control interface. To unlock, the enrolled user must accord with the following conditions: 1) The current unlock time should be in the effective time of user time zone or group zone. 2) The group which user is must be in Combined Verification.
  • Page 8 16 16 17 Disabled Slide Show Press M/OK > Personalize > User Interface, set Idle Time To Slide Show(s) to be None, or set Slide Show Interval(s) to be disabled. 18 Trouble shooting 17 17 1) Fingerprint can not be read or it takes too long. Check whether a nger or ngerprint sensor is stained with sweat, water, or dust.

Table of Contents