Connectors And Cabling For The 8-Port Asynchronous/ Synchronous Rs-232 Grwic - Cisco CGR 2010 Installing And Connecting

Installing and Connecting the Router

Connectors and Cabling for the 8-Port Asynchronous/ Synchronous RS-232 GRWIC

Table 10 Alternative Terminal and Modem Connections
Console Port Connection
Console port to PC
Console port to terminal
Auxiliary port to modem
-
1
An octal cable or RJ-45 breakout cable is equivalent to a rollover cable.
2
Modify the DB-25 adapter by removing Pin 6 and placing it into the Pin 8 position.
Connectors and Cabling for the 8-Port Asynchronous/ Synchronous
RS-232 GRWIC
The 8-Port Asynchronous/Synchronous Grid Router WAN Interface Card (GRWIC) provides low speed
synchronous/asynchronous serial connections supporting EIA-RS232 for the Cisco CGR 2010 router. See
page 51
The 8-port serial RS-232 GRWIC enables applications such as legacy protocol transport, console server, and dial access
server. Combining a high-density serial GRWIC with the Cisco CGR 2010 router enables utilities to transport Supervisory
Control and Data Acquisition (SCADA) over an IP network.
Figure 23 Cisco 8-Port Serial Async/Sync RS-232 GRWIC
The 8-port serial GRWIC has connectors and cabling that allow high-port densities in the compact GRWIC form factor.
The 8-Port Asynchronous/Synchronous GRWIC uses two high-density 4-port connectors. Each connector supports four
ports of EIA-232 with data communications equipment (DCE) or data terminal equipment (DTE) interfaces. All four ports
on one cable use the same DTE/DCE mode.
Async/Sync RS-232 GRWIC.
Note: The operating temperature range for these cables is -40º C to +60º C.
RJ-45 Cable Type
Straight-through
Straight-through
1
Rollover
Straight-through
Table 11 on page 52
51
Adapter
DCE, DB-9 female
DCE, DB-25 female
2
DCE, DB-25, male
DTE, DB-25, male
outlines the cable specifications for the 8-Port
Figure 23 on