Bottom Bracket - Factor SLiCK Assembly Manual

5-3
Route brake inner wire through wedge and tighten 6-7 Nm
taking care not to change the wedge position
6-1

Bottom Bracket

Clean the inside of the frame bottom bracket & the bottom
bracket cups with an isopropyl alcohol.
5-4
Cut the brake inner wire short enough to prevent it from
contacting the brake spring
6-2
Apply Loctite 641 inside the bottom bracket shell
and install the cups into the frame with BRT-002
bearing press from Enduro Bearings.
Assembly Manual
5-5
Install brake cover by tightening M4x10 bolts to 2 Nm
6-3
Apply Loctite 641 on the grooves of the both bottom bracket
cups.
11