Aerobar Assembly - Factor SLiCK Assembly Manual

3-2
Route the rear derailleur Di2 cable through the
chainstay. Install Di2 cable grommet. Connect to the
Di2 junction B.
3-5
Carefully insert Junction B and all cables through the
bottom bracket shell window.
3-3
Route the front derailleur Di2 cable through the seat
tube hole to the bottom bracket exit window. Connect
to the Di2 Junction B.
4-1

Aerobar Assembly

Note: It is much easier to fully assemble the aerobar, base bar,
shifters, brake levers and route all cables before installing the
assembly onto the stem as a single unit.
Route Di2 cables through extensions and install shifters.
Assembly Manual
3-4
Route the Di2 cable from the Junction A to the Junction B
through the down tube (as pictured) to the bottom bracket
shell exit window.
4-2
2-3
Install extensions through the
extension tower and secure by
tightening the M5x16L bolts to
5 Nm
06