Nose Gear Assembly - Freewing FJ307 User Manual

Slat Assembly
A- Plastic pins
B - Slat connection arm
C- Slat
D - Slat plastic hard point
&
Attention:Slat assembly has 6 pieces.
Please refer to the letter in the plastic to
distinguish: L and R refer to the Left and
Right main wing, Figures 1-3 mean the
direction from wing root to wingtip.
Screws (
PB2. 6x6mm 16pcs )
Refer to the photo on the right
1.Use the screws and glue to attach
the assembled slat sets.
2.Use glue to attach the blister cover to
keep the surface clean.

Nose Gear Assembly

Assemble/disassemble the nose gear
by referring to the following diagrams.
Step 1
T-45 Goshawk
Item No.: FJ307
Version No.: FJ307-V01
D2
1.Use "Slat connection arm(B)" to connect "Slat
(C)" to "Slat plastic hard point (D)".
2. Use "Plastic pins(A)" to attach all parts.
Attention:
After inserting the plastic pin, melt the other
side using a hot tip such as a soldering iron.
Accessories name and specifications
A - Electronic retract
B - E-clip (02.0mm)
C -Retract pin
D -Steering tiller arm
K�
E - Steering rod ring
F - Steering rod
G-Screw (M3x3mm)
H -Spring
I -Screw (PM2x4mm)
J -Main gear strut
Step2
1.Use "Metal pin(B)" and "E-clip(C)" to attach
one side of the slat pushrod to the slat
controller, use "Screw(D)" to attach the other
side to the plastic slat.
Attention:
right side, please distinguish between the two
K -Shock absorbing rod
L - Connecting arm 1
M -Screw (M3x5.2mm)
N -Grub screw(M4x4mm)
0 - Nose wheel axle
(045115mm)
P -Wheel
Q -Washer
R - Connect ing arm 2
S -Screw (PA2x8mm)
T -Plastic retract rod
u-
Step 3
-7-
A- Slat pushrod
D - Screw
B - Metal pin
E - Slat controller
C - E-clip
The slat controller has a left and
U -Plastic launching hook
V -Shock absorber supporting rod 2
W -Shock absorber supporting rod 1
x -Pin
Y -Pin
Z - Pin
AA -Pin
AB -Collar
AC -LED landing light
>3-:- -
x· � "'---'"'"--''
y
►
�
�-
s
y
Step4